SAA-C01 Free Practice Test

After creating a new IAM user which of the following must be done before they can successfully make API calls?

1. A. Add a password to the user.
2. B. Enable Multi-Factor Authentication for the user.
3. C. Assign a Password Policy to the user.
4. D. Create a set of Access Keys for the use

Correct Answer: D

What is the maximum write throughput I can provision per table for a single DynamoDB table?

1. A. 5,000 us east, 1,000 all other regions
2. B. 100,000 us east, 10, 000 all other regions
3. C. Designed to scale without limits, but if you go beyond 40,000 us east/10,000 all other regions you have to contact AWS first.
4. D. There is no limit

Correct Answer: C

Your Amazon VPC has a public subnet with a route that sends all Internet traffic to the Internet gateway. An Amazon EC2 instance in the public subnet has an assigned private IP address. The instance belongs to a security group set to allow all outbound traffic. The instance cannot access the Internet.
Why could the Internet be unreachable from this instance?

1. A. The instance does not have a public IP address.
2. B. The internet gateway security group must allow all outbound traffic.
3. C. The instance security group must allow all inbound traffic.
4. D. The instance "Source/Destination check" property must be enable

Correct Answer: A

Can a user get a notification of each instance start / terminate configured with Auto Scaling?

1. A. Yes, if configured with the Launch Config
2. B. Yes, always
3. C. Yes, if configured with the Auto Scaling group
4. D. No

Correct Answer: C
The user can get notifications using SNS if he has configured the notifications while creating the Auto Scaling group.

After an Amazon VPC instance is launched, can I change the VPC security groups it belongs to?

1. A. N
2. B. You cannot.
3. C. Ye
4. D. You can.
5. E. Only if you are the root user
6. F. Only if the tag "VPC_Change_Group" is true

Correct Answer: B
Security groups are associated with network interfaces. After you launch an instance, you can change the security groups associated with the instance, which changes the security groups associated with the primary network interface (eth0).