NSE7_SDW-7.2 Free Practice Test

Refer to the exhibit, which shows the IPsec phase 1 configuration of a spoke.

What must you configure on the IPsec phase 1 configuration for ADVPN to work with SD- WAN?

1. A. You must set ike-version to 1.
2. B. You must enable net-device.
3. C. You must enable auto-discovery-sender.
4. D. You must disable idle-timeout.

Correct Answer: B

Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.


The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.
Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?

1. A. Create a new firewall policy, and the select the SD-WAN zone as Incoming Interface.
2. B. In the traffic shaping policy, select Assign Shaping Class ID as Action.
3. C. In the firewall policy, select Proxy-based as Inspection Mode.
4. D. In the traffic shaping policy, enable Reverse shaper, and then select the traffic shaper to use.

Correct Answer: D

Refer to the exhibits. Exhibit A -

Exhibit B -

Exhibit A shows the traffic shaping policy and exhibit B shows the firewall policy.
The administrator wants FortiGate to limit the bandwidth used by YouTube. When testing, the administrator determines that FortiGate does not apply traffic shaping on YouTube traffic.
Based on the policies shown in the exhibits, what configuration change must be made so FortiGate performs traffic shaping on YouTube traffic?

1. A. Destination internet service must be enabled on the traffic shaping policy.
2. B. Application control must be enabled on the firewall policy.
3. C. Web filtering must be enabled on the firewall policy.
4. D. Individual SD-WAN members must be selected as the outgoing interface on the traffic shaping policy.

Correct Answer: C

Refer to the exhibit.

The exhibit shows the BGP configuration on the hub in a hub-and-spoke topology. The administrator wants BGP to advertise prefixes from spokes to other spokes over the IPsec overlays, including additional paths. However, when looking at the spoke routing table, the administrator does not see the prefixes from other spokes and the additional paths.
Based on the exhibit, which three settings must the administrator configure inside each BGP neighbor group so spokes can learn other spokes prefixes and their additional paths? (Choose three.)

1. A. Set additional-path to send
2. B. Enable route-reflector-client
3. C. Set advertisement-interval to the number of additional paths to advertise
4. D. Set adv-additional-path to the number of additional paths to advertise
5. E. Enable soft-reconfiguration

Correct Answer: ABD

Refer to the exhibits. Exhibit A -

Exhibit B -

Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SD-WAN member status, the routing table, and the performance SLA status.
If port2 is detected dead by FortiGate, what is the expected behavior?

1. A. Port2 becomes alive after three successful probes are detected.
2. B. FortiGate removes all static routes for port2.
3. C. The administrator manually restores the static routes for port2, if port2 becomes alive.
4. D. Host 8.8.8.8 is reachable through port1 and port2.

Correct Answer: B
This is due to Update static route is enable which removes the static route entry referencing the interface if the interface is dead