NSE7_SDW-7.2 Free Practice Test

Refer to the exhibit.

The device exchanges routes using IBGP.
Which two statements are correct about the IBGP configuration and routing information on the device? (Choose two.)

1. A. Each BGP route is three hops away from the destination.
2. B. ibgp-multipath is disabled.
3. C. additional-path is enabled.
4. D. You can run the get router info routing-table database command to display the additional paths.

Correct Answer: CD

Which diagnostic command can you use to show the member utilization statistics measured by performance SLAs for the last 10 minutes?

1. A. diagnose sys sdwan sla-log
2. B. diagnose ays sdwan health-check
3. C. diagnose sys sdwan intf-sla-log
4. D. diagnose sys sdwan log

Correct Answer: A

What does enabling the exchange-interface-ip setting enable FortiGate devices to exchange?

1. A. The gateway address of their IPsec interfaces
2. B. The tunnel ID of their IPsec interfaces
3. C. The IP address of their IPsec interfaces
4. D. The name of their IPsec interfaces

Correct Answer: C

What three characteristics apply to provisioning templates available on FortiManager? (Choose three.)

1. A. You can apply a system template and a CLI template to the same FortiGate device.
2. B. A CLI template can be of type CLI script or Perl script.
3. C. A template group can include a system template and an SD-WAN template.
4. D. A template group can contain CLI templates of both types.
5. E. Templates are applied in order, from top to bottom.

Correct Answer: BDE
According to the FortiManager Administration Guide, provisioning templates are used to configure FortiGate devices in a consistent and efficient way. There are different types of templates, such as system, IPsec, SD-WAN, certificate, and CLI templates. Some characteristics of provisioning templates are:
✑ You can apply a system template and a CLI template to the same FortiGate device, as long as they do not have conflicting settings1.
✑ A CLI template can be of type CLI script or Perl script. A CLI script template contains FortiOS CLI commands, while a Perl script template contains Perl code that can generate FortiOS CLI commands2.
✑ A template group can include a system template and an SD-WAN template, as well as other types of templates. A template group is a collection of templates that can be applied to multiple devices at once3.
✑ A template group can contain CLI templates of both types, as long as they do not have conflicting settings2.
✑ Templates are applied in order, from top to bottom. The order of the templates in a template group determines the order in which they are applied to the devices3.

What is the route-tag setting in an SD-WAN rule used for?

1. A. To indicate the routes for health check probes.
2. B. To indicate the destination of a rule based on learned BGP prefixes.
3. C. To indicate the routes that can be used for routing SD-WAN traffic.
4. D. To indicate the members that can be used to route SD-WAN traffic.

Correct Answer: B