NSE7_SDW-6.4 Free Practice Test

Refer to the exhibit.

Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)

1. A. Set priority 10.
2. B. Set cost 15.
3. C. Set load-balance-mode source-ip-ip-based.
4. D. Set source 100.64.1.1.

Correct Answer: D

Refer to exhibits.


Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.
Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?

1. A. The reverse shaper option must be enabled and a traffic shaper must be selected
2. B. The guaranteed-10mbps option must be selected as the reverse shaper option.
3. C. A new firewall policy must be created and SD-WAN must be selected as the incoming interface.
4. D. The guaranteed-10mbps option must be selected as the per-IP shaper option

Correct Answer: B

Refer to exhibits. Exhibit A.

Exhibit B.

Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static
routes configuration.
Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds
Which statement about the dead member is correct?

1. A. Subnets 100 .64.1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1
2. B. SD-WAN interface becomes disabled and port1 becomes the WAN interface
3. C. Dead members require manual administrator access to bring them back alive
4. D. Port2 might become alive when a single response is received from an SLA server

Correct Answer: A

Which statement is correct about the SD-WAN and ADVPN?

1. A. ADVPN interface can be a member of SD-WAN interface.
2. B. Dynamic VPN is not supported as an SD-Wan interface.
3. C. Spoke support dynamic VPN as a static interface.
4. D. Hub FortiGate is limited to use ADVPN as SD-WAN member interface.

Correct Answer: A

What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )

1. A. Specify outgoing interface routing cost.
2. B. Configure SD-WAN rules interface preference.
3. C. Select SD-WAN balancing strategy.
4. D. Specify incoming interfaces in SD-WAN rules.

Correct Answer: AB