NSE6_FWF-6.4 Free Practice Test

Which administrative access method must be enabled on a FortiGate interface to allow APs to connect and function?

1. A. Security Fabric
2. B. SSH
3. C. HTTPS
4. D. FortiTelemetry

Correct Answer: A

You are investigating a wireless performance issue and you are trying to audit the neighboring APs in the PF environment. You review the Rogue APs widget on the GUI but it is empty, despite the known presence of other APs.
Which configuration change will allow neighboring APs to be successfully detected?

1. A. Enable Locate WiFi clients when not connected in the relevant AP profiles.
2. B. Enable Monitor channel utilization on the relevant AP profiles.
3. C. Ensure that all allowed channels are enabled for the AP radios.
4. D. Enable Radio resource provisioning on the relevant AP profiles.

Correct Answer: D
The ARRP (Automatic Radio Resource Provisioning) profile improves upon DARRP (Distributed Automatic Radio Resource Provisioning) by allowing more factors to be considered to optimize channel selection among FortiAPs. DARRP uses the neighbor APs channels and signal strength collected from the background scan for channel selection.

Which two phases are part of the process to plan a wireless design project? (Choose two.)

1. A. Project information phase
2. B. Hardware selection phase
3. C. Site survey phase
4. D. Installation phase

Correct Answer: AC

What is the first discovery method used by FortiAP to locate the FortiGate wireless controller in the default configuration?

1. A. DHCP
2. B. Static
3. C. Broadcast
4. D. Multicast

Correct Answer: B

When configuring Auto TX Power control on an AP radio, which two statements best describe how the radio responds? (Choose two.)

1. A. When the AP detects any other wireless signal stronger that -70 dBm, it will reduce its transmission power until it reaches the minimum configured TX power limit.
2. B. When the AP detects PF Interference from an unknown source such as a cordless phone with a signal stronger that -70 dBm, it will increase its transmission power until it reaches the maximum configured TX power limit.
3. C. When the AP detects any wireless client signal weaker than -70 dBm, it will reduce its transmission power until it reaches the maximum configured TX power limit.
4. D. When the AP detects any interference from a trusted neighboring AP stronger that -70 dBm, it will reduce its transmission power until it reaches the minimum configured TX power limit.

Correct Answer: AC