NSE5_FMG-7.0 Free Practice Test

- (Exam Topic 1)
Which two statements about the scheduled backup of FortiManager are true? (Choose two.)

1. A. It does not back up firmware images saved on FortiManager.
2. B. It can be configured using the CLI and GUI.
3. C. It backs up all devices and the FortiGuard database.
4. D. It supports FTP, SCP, and SFTP.

Correct Answer: AD
Reference: https://docs.ansible.com/ansible/latest/collections/fortinet/fortimanager/fmgr_system_backup_allsettings_modul

- (Exam Topic 1)
An administrator would like to create an SD-WAN using central management in the Training ADOM.
To create an SD-WAN using central management, which two steps must be completed? (Choose two.)

1. A. Specify a gateway address when you create a default SD-WAN static route
2. B. Enable SD-WAN central management in the Training ADOM
3. C. Configure and install the SD-WAN firewall policy and SD-WAN static route before installing the SD-WANtemplate settings
4. D. Remove all the interface references such as routes or policies that will be a part of SD-WAN member interfaces

Correct Answer: BD
Reference:
https://docs.fortinet.com/document/fortigate/6.0.0/cookbook/676493/removing-existing-configuration-reference

- (Exam Topic 2)
Refer to the exhibit.

Given the configuration shown in the exhibit, which two statements are true? (Choose two.)

1. A. It allows two or more administrators to make configuration changes at the same time, in the same ADOM.
2. B. It disables concurrent read-write access to an ADOM.
3. C. It allows the same administrator to lock more than one ADOM at the same time.
4. D. It is used to validate administrator login attempts through external servers.

Correct Answer: BC
Reference:
https://docs.fortinet.com/document/fortimanager/6.0.4/administration-guide/86456/concurrentadom-access

- (Exam Topic 1)
When an installation is performed from FortiManager, what is the recovery logic used between FortiManager and FortiGate for an FGFM tunnel?

1. A. After 15 minutes, FortiGate will unset all CLI commands that were part of the installation that caused the tunnel to go down.
2. B. FortiManager will revert and install a previous configuration revision on the managed FortiGate.
3. C. FortiGate will reject the CLI commands that will cause the tunnel to go down.
4. D. FortiManager will not push the CLI commands as a part of the installation that will cause the tunnel to go down.

Correct Answer: A
The configuration change will break the fgfm connection, causing the FortiGate unit to attempt to reconnect for 900 seconds. If the FortiGate cannot reconnect, it will rollback to its previous configuration.

- (Exam Topic 1)
Refer to the exhibit.

You are using the Quick Install option to install configuration changes on the managed FortiGate.
Which two statements correctly describe the result? (Choose two.)

1. A. It will not create a new revision in the revision history
2. B. It installs device-level changes to FortiGate without launching the Install Wizard
3. C. It cannot be canceled once initiated and changes will be installed on the managed device
4. D. It provides the option to preview configuration changes prior to installing them

Correct Answer: BC
FortiManager_6.4_Study_Guide-Online – page 164
The Install Config option allows you to perform a quick installation of device-level settings without launching the Install Wizard. When you use this option, you cannot preview the changes prior to committing. Administrator should be certain of the changes before using this install option, because the install can’t be cancelled after the process is initiated.