NS0-592 Free Practice Test

A customer called you after a failure in their Microsoft Hyper-V environment on the “SVM1” SVM. The customer wants to enable nondisruptive operations (NDO) to prevent future failures.
In this scenario, which two actions must be performed? (Choose two.)

1. A. Verify that the continuously-available option is set on the CIFS share.
2. B. Verify that SMB2 is enabled.
3. C. Verify that SMB3 is enabled.
4. D. Verify that the branchcache option is set on the CIFS share.

Correct Answer: AB

The error message shown below is reported in the EMS log file.
“[sis.changelog.full:warning]: Change logging metafile on volume DATA1 is full and can not hold any more
fingerprint entries.”
What are two ways to solve this problem? (Choose two.)

1. A. Clear the changelog manually so that the operation can restart.
2. B. Increase the size of the changelog to allow the operation to continue.
3. C. Modify the storage efficiency policy so that deduplication runs more frequently.
4. D. Modify the threshold that triggers a deduplication operation.

Correct Answer: BD

You configured iSCSI multipathing on a Windows host to a 2-node ONTAP cluster so that you can attach to some LUNs. You see that the host logging in to both iSCSI LIFs in the ONTAP cluster, and you notice that the igroup is correctly set. After you open Disk Management and rescan for disks, the NetApp LUNs do not show up.
In this scenario, what should be performed to enable the LUNs to be visible to the Windows host?

1. A. Set up LUN mapping and try scanning again.
2. B. Configure the SVM for FCP and try scanning again.
3. C. Set up Selective LUN Mapping (SLM) and try scanning again.
4. D. Configure the ONTAP nodes for HA and try scanning again.

Correct Answer: C

Click the exhibit button.

Your customer reports that their FAS2554A system reports multi-path HA when running the sysconfig command. However, Config Advisor reports an error about incorrect cabling.
What are the two reasons for the messages? (Choose two.)

1. A. Shelves 10 and 20 have different IOM modules and must be in separate stacks.
2. B. The FAS2554 system is cabled incorrectly to shelf ID 20.
3. C. The DS2246 shelf is wrong; the shelf ID must be 11.
4. D. Disk shelves 10 and 20 are cabled incorrectly to each other.

Correct Answer: BD

Click the exhibit button.

A customer has an FC SAN with brocade switches. Each server attached to the SAN gas four FC ports. The customer describes that one of their servers has only four paths to the LUNs configured on the cluster. There should be eight paths on all the other servers. The switch administrator has verified the zone configuration.
Referring to the exhibit, which two actions would you perform to troubleshoot the problem? (Choose two.)

1. A. Review the LIF configuration on the cluster.
2. B. Review the driver version on the server.
3. C. Review that the host side FC link ports are enabled.
4. D. Review the igroup configuration on the cluster.

Correct Answer: AB