HPE0-S59 Free Practice Test

Which compute node parameters are captured within server hardware type?

1. A. Number of the CPUs
2. B. installed operating system
3. C. Mezzanine card configuration
4. D. Size of the memory Installed

Correct Answer: B

Which statement about the HPE D3940 storage module is true?

1. A. SATA drives requires redundant 10 adapters to be installed in this module
2. B. Up to five modules can be installed in a single frame with Gen10 servers
3. C. it is configured through CLl available from HPE Synergy console
4. D. Only one type of drives (SATA, SAS, SSD) can be installed in each module

Correct Answer: C

Your customer added a new Ethernet network in HPE Oneview mat is used to manage their HPE Synergy platform.
When the customer tries to connect one of the compute nodes to this network through the server profile, this network is not available.
What must be done to fix this issue?

1. A. Check the Logical Enclosure settings and verify if the maximum number of networks allowed for this LE is reached.
2. B. To make this network available to use in the server profile, the customer must enable the Smart Link feature within network definition.
3. C. The newly created network must be added to the uplink set within the LIG, and Logical interconnect configuration must be updated from the LIG.
4. D. Check within the server profile which server hardware is used and perform the Refresh operation on thiscompute node to get the latest adapter information.

Correct Answer: C

Your customer reports that they cannot deploy HPE Synergy compute nodes using HPE OneView for VMware vCenter Server (HPE OV4VC).
What should you check during troubleshooting process?

1. A. If HPE OneView credentials are added in vCenter Server
2. B. If an compute nodes are added to the vCenter Server
3. C. If the HPE Oneview instance Is integrated with HPE OV4VC.
4. D. If vCenter Server is licensed in the HPE Oneview interface

Correct Answer: B

Your customer plans to use HPE Primera to boot HPE Synergy compute nodes. They currently have two HPE Virtual Connect SE 100Gb F32 Module for Synergy modules installed in the frame. The customer wants to use FC as a storage access protocol
What must be done to complete this task?

1. A. Enable FC primary and secondary boot on the modules through the HPE OneView interface
2. B. FC connectivity on the modules should be enabled through the service console by disabling FCoE.
3. C. Add FC upgrade licenses in HPE OneView that will enable FC connectivity for the modules
4. D. Enter both modules into a maintenance mode, then enable FC connectivity through CLI

Correct Answer: B