352-001 Free Practice Test

Refer the exhibit.
<>>

1. A. R3 advertises the link from R3-R2 to R1, R4 and R5 only.
2. B. R2 receives an IPv6 default route from R3.
3. C. Only R3 and R2 have IPv4 and IPv6 reachability.
4. D. Loopback reachability between all routers for IPv4 is lost.
5. E. All routers except R2 are reachable through IPv4.

Correct Answer: D

Which three options are IS-IS design considerations when connecting two Layer 3 switches directly using a 10 GBASE-T cabling and formatting an IS-IS neighbor adjacency?

1. A. The default IS-IS network type is point-to-point so a DIS is not elected
2. B. A DIS is elected between the IS-IS neighbors and the elected DIS is pre-empted if router with a higher system ID is connected
3. C. The area, levels, and interface MTU parameters must match, and system MTU must be unique for two IS-IS routers to become adjacent
4. D. Faster IS-IS hello and dead timers increase bandwidth and CPU use, and may cause instability
5. E. The IS-IS hello and dead timers should be tuned to detect failures as quickly as possible
6. F. A DIS is elected between the IS-IS neighbors and the elected Dis is pre-empted if a router with a lower system ID is connected
7. G. The hello and dead timers must match for two IS-IS routers to become adjacent

Correct Answer: CDF

DRAG DROP
Refer to the exhibit.
< ><>>< >
Solution:


Does this meet the goal?

1. A. Yes
2. B. No

Correct Answer: A

A large enterprise network has a partial mesh network with multiples redundant links. OSPF is used
as IGP and it is implemented in a single-area. The network has slow convergence times and there is a high CPU utilization on the routers. Which solution can address these issues while ensuring that the network scales?

1. A. Break the routing domain into separate OSPF areas
2. B. Make it a hub-and-spoke topology
3. C. Replace OSPF with BGP
4. D. Reduce the number of links between routers in the network
5. E. Upgrade the routers with higher CPU and memory resources

Correct Answer: A

You are designing a WAN network solution with EIGRP based on VPLS. The interface speed is 10Mb/s,
but the access rate of the WAN connection is 256 Kb/s. What should you include in the network design, in order to avoid potential issues with EIGRP?

1. A. Limit EIGRP traffic to the access rate with a policer.
2. B. Tag outbound EIGRP traffic and have the WAN provider add it to the priority queue.
3. C. Limit traffic to the access rate with interface traffic shaping.
4. D. Set the interface bandwidth to match the access rate.

Correct Answer: D