350-801 Free Practice Test

Refer to the exhibit.

An administrator must replace the T1 card with an E1 card. What is the correct configuration if the administrator was asked to configure 12 time slots?

1. A.
2. B.
3. C.
4. D.

Correct Answer: C

When designing the capacity for a Cisco UCM 12.x cluster, an engineer must decide which VMware template will be used for each node. What is the lowest number of users supported in a template and the highest number of users in a template?

1. A. 750 and 15.000 users
2. B. 750 and 10.000 users
3. C. 500 and 10.000 users
4. D. 1000 and 10.000 users

Correct Answer: D

Refer to the exhibit.


A collaboration engineer is configuring the Cisco UCM IM and Presence Service. Which two steps complete the configuration of the SIP trunk security profile? (Choose two.)

1. A. Check the box to enable application-level authorization.
2. B. Check the box to allow charging header.
3. C. Check the box to accept unsolicited notification.
4. D. Check the box to transmit security status.
5. E. Check the box to accept replaces header.

Correct Answer: CE

What is the maximum number of servers that are in an IM and Presence presence redundancy group?

1. A. 10
2. B. 6
3. C. 2
4. D. 4

Correct Answer: C

An administrator uses the Cisco Unified Real-Time Monitoring Tool to investigate recent calls on a Cisco UCM cluster. The SIP trace for an on-net. direct-media call shows two 180 Ringing and two 11 BYE messages. Why are there multiples of each message type in the trace?

1. A. The source phone sends a 180 Ringing signal to the Cisco UC
2. B. which sends a 180 Ringing signal to the destination phon
3. C. The same process applies to 11 BYE messages.
4. D. The source phone must signal to the destination phone that it is ringing, and the destination phone signals back with a 180 Ringing messag
5. E. The same process applies to 11 BYE messages.
6. F. The calls have an MTP in the call path due to different codec suppor
7. G. The calls are subsequently split into two call legs.
8. H. The destination phone signals back to the Cisco UCM that it is ringing, and the Cisco UCM signals back to the source phone.

Correct Answer: A