350-801 Free Practice Test

Refer to the exhibit.

An engineer is troubleshooting why PSTN phones are not receiving the caller's name when called from a remote Cisco UCM site. An ISDN PRI connection is being used to reach the PSTN What must the administrator select to resolve the issue?

1. A. isdn supp-service name calling
2. B. isdn outgoing display-ie
3. C. isdn enable did
4. D. isdn send display le

Correct Answer: B

Which wildcard must an engineer configure to match a whole domain in SIP route patterns?

1. A. *
2. B. @
3. C. !
4. D. .

Correct Answer: A
The asterisk (*) wildcard is used to match any sequence of characters, including an empty sequence. Therefore, it can be used to match any domain name in a SIP Route Pattern.
The other options are not correct because:
C. !: The ! symbol is used to negate a character class.
D. .: The . symbol is used to match any single character.

On a cisco catalyst switch which command is required to send CDP packets on a switch port that configures a cisco IP phone to transmit voice traffic in 802.1q frames tagged with the voice VLAN ID 221?

1. A. Device(config-if)# switchport access vlan 221
2. B. Device(config-if)# switchport vlan voice 221
3. C. Device(config~if)# switchport trunk allowed vlan 221
4. D. Device(config-if)# switchport voice vlan 221

Correct Answer: D

Refer to the exhibit.

Calls to Cisco Unity Connection are failing across Cisco Unified Border Element when callers try to select a menu prompt Why is this happening and how is it fixed?

1. A. Cisco Unity Connection is configured on G.729 onl
2. B. Cisco Unity Connection must be reconfigured to support iLBC.
3. C. Cisco Unified Border Element is not sending any support for DTM
4. D. OTMF configuration must be added to the appropriate dial peer.
5. E. Cisco Unified Border Element is sending the incorrect media IP addres
6. F. The IP address of the loopback interface must be advertised in the SDP
7. G. The Cisco Unity Connection Call Handler is configured for a "Release to Switch" transfer type Transfers must be disabled for the Cisco Unity Connection Call Handler

Correct Answer: B

Which command must be defined before an administrator changes the linecode value on an ISDN T1 PRI in slot 0/2 on an IOS-XE gateway?

1. A. isdn incoming-voice voice
2. B. pri-group timeslots 1-24
3. C. card type t1 0 2
4. D. voice-port 0/2/0:23

Correct Answer: C