350-601 Free Practice Test

An engineer is converting a Cisco MDS switch to support NPIV mode. What should be considered when implementing the solution?

1. A. It must be enabled on VSAN 1 only.
2. B. It must be enabled globally on all VSANs.
3. C. It requires mapping of external interface traffic.
4. D. It requires the FLOGI database to be disabled.

Correct Answer: B
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/mds9000/sw/5_0/configuration/guides/int/nxos/cli_i

Which two statements about the process of upgrading an EPLD on a Cisco MDS 9000 series Switch are correct? (Choose two.)

1. A. The EPLDs for all the modules on a switch must be upgraded at the same time.
2. B. EPLD upgrades can be completed without powering down the module during the upgrade.
3. C. EPLDs can be upgraded only to the latest EPLD image.
4. D. EPLDs can be upgraded without replacing the hardware.
5. E. An upgrade verification identifies the impact of each EPLD upgrade.

Correct Answer: DE
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/mds9000/sw/7_3/upgrade/upgrade.html

An engineer must configure a monitoring solution for a Cisco Nexus 9000 Series Switch based data center. The solution must provide real-time insight into the network health with subscription-based monitoring. The monitoring must be initiated from the client side, and the data must be sent via encryption. Which configuration steps complete the configuration?

1. A. Option A
2. B. Option B
3. C. Option C
4. D. Option D

Correct Answer: A

An engineer must configure a Cisco UCS blade system that is managed by Cisco UCS Manager. All four connected interfaces between the blade system and the fabric interconnects must be used. Additionally, the connectivity must tolerate any link failure between the l/O module and the fabric interconnects. Which action accomplishes these requirements?

1. A. Configure port aggregation with LACP policy set to default
2. B. Configure Firmware Auto Sync Server policy to Auto Acknowledge
3. C. Configure Link Group Preference to Port Channel.
4. D. Configure chassis/FEX discovery pokey action to four links

Correct Answer: D

Cisco Nexus 9000 Series Switches are configured with LACP protocol and default aging timers. What is the impact on the LACP peer during an ISSU upgrade?

1. A. The LACP peer connection terminates.
2. B. The LACP peer session remains up.
3. C. The LACP peer renegotiates the adjacency.
4. D. The LACP peer connection resets.

Correct Answer: B
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus9000/sw/6-x/interfaces/configuration/guide/b_ ISSU and ungraceful switchovers are not supported with LACP fast timers.