350-501 Free Practice Test

Refer to the exhibit.

EIGRP is running between routers R5 and R1, and OSPF is used in the rest of the network. Users in a network attached to router R3 need to access a server connected to R5. Which task must the engineer perform so that only the users attached to R3 are able to access the server, but no other network is shared to OSPF?

1. A. Configure redistribution using route maps to filter the routes that are shared
2. B. Configure redistribution using an offset list to filter the routes that are shared.
3. C. Configure an OSPF virtual link between R1 and R3 to route traffic between the two areas.
4. D. Configure R1 as a stub router for EIGRP and OSPF so that only the default route is shared

Correct Answer: A

Refer to the exhibit.

A network engineer received a complaint about these problems in OSPF stub area 100:
The Ethernet link is down between routers RX and RY because the fiber was cut.
CE site A traffic to the hub site is being dropped. Which action resolves these issues?

1. A. Set the OSPF authentication type to MD5 between RX and RY DUMPS
2. B. Change the OSPF area 100 type to stub on RZ.
3. C. Change the OSPF priority to 100 on the interfaces that connect RX and RY.
4. D. DUMPS Set the OSPF MTU to 1500 on the link between RX and RZ.

Correct Answer: B

Refer to the exhibit.


LDP peering between routers R1 and R2 is dropped when the link between R1 and R2 is taken offline. However, LDP peering between R2 and R3 stays up when the link between R2 and R3 is taken offline. Which action allows MPLS traffic forwarding to continue normally if the link between R1 and R2 goes down?

1. A. Enable IGP and LDP Synchronization on R1.
2. B. Implement LDP Session Protection on R1.
3. C. Enable IGP and LDP Synchronization on R2.
4. D. Implement LDP Session Protection on R2.

Correct Answer: B

A network engineer is adding 10Gbps link to an existing 2X1Gbps LACP-based LAG to augment its capacity. Network standards require a bundle interface to be take out of service if one of its member links does down, and the new link must be added with minimal impact to the production network. Drag and drop the tasks that the engineer must perform from the left into the sequence on the right. Not all options are used.

Solution:
Application, table Description automatically generated with medium confidence

Does this meet the goal?

1. A. Yes
2. B. No

Correct Answer: A

Refer to the exhibit:

Which command is used to complete this configuration for QoS class-based marking?

1. A. PE-A(config-pmap-c)#set dscp ef
2. B. PE-A(config-pmap-c)#fair-queue
3. C. PE-A(config-pmap-c)#random-detect
4. D. PE-A(config -pmap-c)#priority

Correct Answer: A