350-501 Free Practice Test

Refer to the exhibit.

An engineer has started to configure a router for OSPF, as shown Which configuration must an engineer apply on the network so that area 15 traffic from R5 to R1 will prefer the route through R4?

1. A. Place the link between R3 and R5 in a stub area to force traffic to use the route through R4.
2. B. Increase the cost on the link between R2 and R4, to influence the path over R3 and R4.
3. C. Implement a multiarea adjacency on the link between R2 and R4, with the cost manipulated to make the path through R4 preferred.
4. D. Implement a sham link on the between R3 and R2 to extend area 0 area 15.

Correct Answer: B

A network engineer is configuring Flexible NetFlow and enters these commands

What are two results of implementing this feature instead of traditional NetFlow? (Choose two.)

1. A. CPU and memory utilization are reduced.
2. B. Only the flows of top 100 talkers are exported.
3. C. The data export flow is more secure
4. D. The number of packets to be analyzed are reduced.
5. E. The accuracy of the data to be analyzed is improved.

Correct Answer: AD

After a series of unexpected device failures on the network. a Cisco engineer is deploying NSF on the network devices so that packets continue to be forwarded during switchovers The network devices reside in the same holding, but they are physically separated into two different data centers Which task must the engineer perform as part of the deployment?

1. A. implement OSPF to maintain the link-state database during failover.
2. B. implement VRFs and specify the forwarding instances that must remain active during failover.
3. C. implement an L2VPN with the failover peer to share state Information between the active and standby devices.
4. D. implement Cisco Express Forwarding to provide forwarding during failover

Correct Answer: B

Which MPLS design attribute can you use to provide Internet access to a major customer through a separate dedicated VPN?

1. A. The customer that needs the Internet access service is assigned to the same RTs as the Internet gateway
2. B. The Internet gateway inserts the full Internet BGP routing table into the Internet access VPN
3. C. The Internet gateway router is connected as a PE router to the MPLS backbone.
4. D. The CE router supports VRF-Ute and the full BGP routing table.

Correct Answer: B

A network engineer must implement SNMPv2 with these parameters
Enable SNMP community string C1sc0 with read-only permissions.
Enable interface index persistence.
Restrict the SNMP community to only the monitoring server with IP address 198.18 19 100/32.
Provide view-only access to ospflfEntry and ospfNbrEntry.
Which configuration must the engineer apply?

1. A. Option A
2. B. Option B
3. C. Option C
4. D. Option D

Correct Answer: A