350-501 Free Practice Test

Which module refers to the network automation using Ansible?

1. A. the iosxr_system module to collect facts from remote devices
2. B. the iosxr_user module to manage banners for users in the local database
3. C. the losxr_logging module to run debugging for seventy levels 2 to 5
4. D. the iosxr_command module to issue run commands on remote devices

Correct Answer: D
https://docs.ansible.com/ansible/latest/collections/cisco/iosxr/iosxr_command_module.html#ansible-collections-

An engineer must extend Layer 2 Between two campus sites connected through an MPLS backbone that encapsulates Layer 2 and Layer 3 data Which action must the engineer perform on the routers to accomplish this task?

1. A. Configure a EtherChannel for E-LAN.
2. B. Configure a pseudowire for E-LINE.
3. C. Configure Cisco MPLS TE for use with E-TREE.
4. D. Configure QoS for MPLS and E-ACCESS

Correct Answer: B

Drag and drop the functionalities from the left onto the correct target fields on the right.

Solution:


Does this meet the goal?

1. A. Yes
2. B. No

Correct Answer: A

Refer to the exhibit.

An engineer started to configure a router for OSPF. Which configuration must the engineer perform on the router without changing any interface configuration so that the router establishes an OSPF neighbor relationship with its peer?

1. A. router(config)# router ospf 11router(config-if)# no passive-interface ethernet 1/1
2. B. router(config)# interface ethernet 1/1router(config-if)# no shutdown
3. C. router(config)# interface ethernet 1/1router(config-if)# ip ospf hello-interval
4. D. router(config)# interface ethernet 1/1router(config-if)# ip ospf priority 0

Correct Answer: A

Refer to the exhibit.

A network engineer is implementing BGP in AS 65101 and AS 65201. R3 sends data traffic to 192.168.1.1 /32 via the path R3-R2-R1. The traffic must travel via alternate path R6-R5 for prefix 192.168.1.1/32. Which action must be taken to meet the requirement?

1. A. Apply route-map HIGH-MED out on R2 for neighbor R3.
2. B. Apply route-map HIGH-LP in on R3 for neighbor R6
3. C. Apply route-map LOW-LP out on R2 for neighbor R3.
4. D. Apply route-map LOW-MED in on R5 for neighbor R2

Correct Answer: A