350-401 Free Practice Test

- (Exam Topic 2)
Which method is used by an AP to join HA controllers and is configured in NVRAM?

1. A. stored WLC information
2. B. DNS
3. C. IP Helper Addresses
4. D. Primary/Secondary/Tertiary/Backup

Correct Answer: A
An AP can be “primed” with up to three controllers—a primary, a secondary, and a tertiary. These are stored in nonvolatile memory so that the AP can remember them after a reboot or power failure.

- (Exam Topic 1)
Which characteristic distinguishes Ansible from Chef?

1. A. Ansible lacs redundancy support for the master serve
2. B. Chef runs two masters in an active/active mode.
3. C. Ansible uses Ruby to manage configuration
4. D. Chef uses YAML to manage configurations.
5. E. Ansible pushes the configuration to the clien
6. F. Chef client pulls the configuration from the server.
7. G. The Ansible server can run on Linux, Unix or Window
8. H. The Chef server must run on Linux or Unix.

Correct Answer: C

- (Exam Topic 2)
What is the wireless received signal strength indicator?

1. A. The value given to the strength of the wireless signal received compared to the noise level
2. B. The value of how strong the wireless signal Is leaving the antenna using transmit power, cable loss, and antenna gain
3. C. The value of how much wireless signal is lost over a defined amount of distance
4. D. The value of how strong a tireless signal is receded, measured in dBm

Correct Answer: D
RSSI, or “Received Signal Strength Indicator,” is a measurement of how well your device can hear a signal from an access point or router. It’s a value that is useful for determining if you have enough signal to get a good wireless connection.
This value is measured in decibels (dBm) from 0 (zero) to -120 (minus 120). The closer to 0 (zero) the stronger the signal is which means it’s better, typically voice networks require a -65db or better signal level while a data network needs -80db or better.

- (Exam Topic 1)
Refer the exhibit.

Which router is the designated router on the segment 192.168.0.0/24?

1. A. This segment has no designated router because it is a nonbroadcast network type.
2. B. This segment has no designated router because it is a p2p network type.
3. C. Router Chicago because it has a lower router ID
4. D. Router NewYork because it has a higher router ID

Correct Answer: B

- (Exam Topic 4)

Refer to the exhibit. An engineer builds an EEM script to apply an access list. Which statement must be added to complete the script?

1. A. event none
2. B. action 2.1 cli command "ip action 3.1 ell command 101''
3. C. action 6.0 ell command ''ip access-list extended 101''
4. D. action 6.0 cli command ''ip access-list extended 101"

Correct Answer: A