- (Exam Topic 3)
Refer to the exhibit.
Which command set must be applied on R1 to establish a BGP neighborship with R2 and to allow communication from R1 to reach the networks?
A)
B)
C)
D)
Correct Answer:
A
- (Exam Topic 2)
What is the function of a control-plane node In a Cisco SD-Access solution?
Correct Answer:
A
- (Exam Topic 3)
Which feature Is used to propagate ARP broadcast, and link-local frames across a Cisco SD-Access fabric to address connectivity needs for silent hosts that require reception of traffic to start communicating?
Correct Answer:
B
Layer2 Flooding
Cisco SD-Access fabric provides many optimizations to improve unicast traffic flow, and to reduce the unnecessary flooding of data such as broadcasts. But, for some traffic and applications, it may be desirable to enable broadcast forwarding within the fabric.
By default, this is disabled in the Cisco SD-Access architecture. If broadcast, Link local multicast and Arp flooding is required, it must be specifically enabled on a per-subnet basis using Layer 2 flooding feature.
Layer 2 flooding can be used to forward broadcasts for certain traffic and
application types which may require leveraging of Layer 2 connectivity, such as silent hosts, card readers, door locks, etc.
- (Exam Topic 4)
Refer to the exhibit.
These commands have been added to the configuration of a switch Which command flags an error if it is added to this configuration?
Correct Answer:
B
- (Exam Topic 4)
Which LISP component decapsulates messages and forwards them to the map server responsible for the egress tunnel routers?
Correct Answer:
B
