350-401 Free Practice Test

- (Topic 1)

Refer to the exhibit. A network engineer configures NAT on R1 and enters the show
command to verity the configuration What does the output confirm?

1. A. The first pocket triggered NAT to add on entry to NAT table
2. B. R1 is configured with NAT overload parameters
3. C. A Telnet from 160.1.1 1 to 10.1.1.10 has been initiated.
4. D. R1 to configured with PAT overload parameters

Correct Answer: A

- (Topic 4)
How does a Type 1 hypervisor function?

1. A. It runs directly on a physical server and depends on a previously installed operating system.
2. B. It runs directly on a physical server and includes its own operating system.
3. C. It runs on a virtual server and depends on a previously installed operating systems
4. D. It runs on a virtual server and includes its own operating system.

Correct Answer: B
A type 1 hypervisor, also known as a bare-metal or native hypervisor, runs directly on the physical server and its underlying hardware. It does not depend on a previously installed operating system, but rather includes its own operating system that is designed to run virtual machines. A type 1 hypervisor provides excellent performance and stability, as it has direct access to the hardware resources and can allocate them to the virtual machines. A type 1 hypervisor is typically used in enterprise environments, where multiple virtual machines run on a single server.
Reference: What is a Hypervisor? Types of Hypervisors 1 & 2 - phoenixNAP

- (Topic 4)
What is one role of the VTEP in a VXLAN environment?

1. A. to forward packets to non-LISP sites
2. B. to encapsulate the tunnel
3. C. to maintain VLAN configuration consistency
4. D. to provide EID-to-RLOC mapping

Correct Answer: B

- (Topic 2)
Refer to the exhibit.

What step resolves the authentication issue?

1. A. use basic authentication
2. B. change the port to 12446
3. C. target 192 168 100 82 in the URI
4. D. restart the vsmart host

Correct Answer: B
he first figure is the output of the “show control connections” command. From this figure we learned that the 192.168.100.82 so we need to connect to this IP address (not 192.168.100.80).

- (Topic 1)
When configuration WPA2 Enterprise on a WLAN, which additional security component configuration is required?

1. A. NTP server
2. B. PKI server
3. C. RADIUS server
4. D. TACACS server

Correct Answer: C