300-625 Free Practice Test

A storage network engineer must configure a 48-port Cisco MDS switch to reject any login requests to VSAN 10 from unauthorized Fibre Channel devices and switches. All the devices that were already logged in to the switch from this VSAN must be allowed without any manual configuration. Which configuration must be applied?

1. A. switch(config)# feature port-security switch(config)# port- security activate vsan 10
2. B. switch(config)# feature port- security switch(config)# port-security activate vsan 10 no auto- learn
3. C. switch(config)# feature port-security switch(config)# port-security database vsan 10 switch(config-port-security)# any-wwn interface fc1/1 – fc1/48
4. D. switch(config)# port-security activate vsan 10

Correct Answer: D

Refer to the exhibit.

A port channel has been configured between a Cisco MDS and a Cisco Fabric Interconnect switch. Which interface(s) in the port channel carry the control plane traffic?

1. A. per packet, balanced between interfaces fc1/9 and fc1/10
2. B. from interface fc1/9
3. C. from interface fc1/10
4. D. per flow, balanced between interfaces fc1/9 and fc1/10

Correct Answer: D

A storage network engineer must install and configure a new MDS switch in a data center network. Which two statements about available choices during the MDS switch initial setup are correct? (Choose two.)

1. A. The engineer can choose what will be the administrator account.
2. B. The secure password standard is required.
3. C. The engineer can configure the default zone policy.
4. D. The engineer can configure the default switch port trunk mode.
5. E. The engineer does not have the choice to enable or disable full zoneset distribution.

Correct Answer: AC

Refer to the exhibit.

Which configuration change improves the ability of the link to recover from frame loss?

1. A. Increase the reset timeout.
2. B. Enable selective acknowledgment.
3. C. Increase the send buffer size to 15000 KB.
4. D. Disable PMTU discovery.

Correct Answer: B

A storage network engineer is implementing SAN telemetry for a SAN infrastructure using Cisco DCNM for SAN. Which command is used to check the session status for telemetry operation?

1. A. show telemetry pipeline stats
2. B. show telemetry transport
3. C. show telemetry control stats
4. D. show analytics system-load

Correct Answer: B