300-620 Free Practice Test

When Cisco ACI connects to an outside Layers 2 network, where does the ACI fabric flood the STP BPDU frame?

1. A. within the bridge domain
2. B. within the APIC
3. C. within the access encap VLAN
4. D. between all the spine and leaf switches

Correct Answer: A
Reference: https://www.cisco.com/c/en/us/solutions/collateral/data-center-virtualization/application-centric-infrastructure/white-paper-c07-732033.html#_Toc395143571

What must be configured to allow SNMP traffic on the APIC controller?

1. A. out-of-band management interface
2. B. contract under tenant mgmt
3. C. SNMP relay policy
4. D. out-of-band bridge domain

Correct Answer: B

Which two types of interfaces are supported on border leaf switches to connect to an external router? (Choose two.)

1. A. subinterface with VXLAN tagging
2. B. subinterface with 802.1Q tagging
3. C. FEX host interface
4. D. out of band interface
5. E. Switch Virtual Interface

Correct Answer: BE

Refer to the exhibit.

Which Adjacency Type value should be set when the client endpoint and the service node interface are in a different subnet?

1. A. Routed
2. B. Unicast
3. C. L3Out
4. D. L3

Correct Answer: D

A situation causes a fault to be raised on the APIC. The ACI administrator does not want that fault to be raised because it is not directly relevant to the environment. Which action should the administrator take to prevent the fault from appearing?

1. A. Under System -> Faults, right-click on the fault and select Acknowledge Fault so that acknowledged faults will immediately disappear.
2. B. Create a stats threshold policy with both rising and falling thresholds defined so that the critical severity threshold matches the squelched threshold.
3. C. Under System -> Faults, right-click on the fault and select Ignore Fault to create a fault severity assignment policy that hides the fault.
4. D. Create a new global health score policy that ignores specific faults as identified by their unique fault code.

Correct Answer: C