300-615 Free Practice Test

An upgrade of protected RPMs from the Bash shell did not take effect. Which action is required for the changes to take effect?

1. A. Restart the Bash shell.
2. B. Reload the switch.
3. C. Upgrade the RPMs from the Guest shell.
4. D. Disable and reenable the Bash feature.

Correct Answer: D

A user reports that they cannot reach from a UCS server to an FC Storage array. Which command is used to test communication between an FCF and a target?

1. A. fcroute
2. B. traceroute
3. C. fcping
4. D. ping

Correct Answer: C

An engineer is troubleshooting a custom AV pair that was created by a client on an external authentication server to map a read-only role for a specific security domain. Which AV pair solves the problem?

1. A. shell:domains=Security_Domain_1//Read_Role_1|Read_Role_2
2. B. shell:domains=Security_Domain_1/Write_Role_1|Read_Role_2
3. C. shell=Security_Domain_1/Read_Role_1|Read_Role_2
4. D. shell:domains=Security_Domain_1/Read_Role_1|Read_Role_2

Correct Answer: A

You have an ACI environment with three APICs, two spine switches, and four-leaf switches. You wipe and reboot all APICs first then leaf and spine switches one-by-one and successfully go through the Initial Setuo dialogue on the APIC 1 CIMC KVM console. When you log in to the APIC1 WebGUI, you notice that you do not see any directly connected leaf switches being discovered under Fabric > Inventory > Fabric Membership. What is the cause of the issue?

1. A. The leaf nodes were not erased properly, which caused a fabric parameters mismatch with the APIC1.
2. B. Rebooting the APICs and the leaf and spine switches after wiping them is not required.
3. C. You forgot to enter the TEP Pool value during the Initial Setup dialogue on APIC1.
4. D. The same Fabric Name value should be used before after wiping all devices.

Correct Answer: C

Refer to the exhibit. Cisco UCS Manager is being upgraded using the Auto Install feature, but the FSM fails. Which action resolves the issue?

1. A. Acknowledge the primary fabric interconnect.
2. B. Remove the service pack from the subordinate fabric interconnect.
3. C. Clear the startup version of the default infrastructure pack.
4. D. Upgrade the firmware of the infrastructure firmware by using the force option.

Correct Answer: C