300-430 Free Practice Test

Where is a Cisco OEAP enabled on a Cisco Catalyst 9800 Series Wireless Controller?

1. A. RF Profile
2. B. Flex Profile
3. C. Policy Profile
4. D. AP Join ProfileCorrect

Correct Answer: B
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/config-guide/b_wl_16_10_cg/flexconnect.html

A wireless engineer must implement a corporate wireless network for a large company in the most efficient way possible. The wireless network must support 32 VLANs for 300 employees in different departments. Which solution must the engineer choose?

1. A. Configure a second WLC to support half of the APs in the deployment.
2. B. Configure one single SSID and implement Cisco ISE for VLAN assignment according to different user roles.
3. C. Configure different AP groups to support different VLANs, so that all of the WLANs can be broadcast on both radios.
4. D. Configure 16 WLANs to be broadcast on the 2.4-GHz band and 16 WLANs to be broadcast on the 5.0-GHz band.

Correct Answer: B

A FlexConnect remote office deployment is using five 2702i APs indoors and two 1532i APs outdoors. When a code upgrade is performed and FlexConnect Smart AP Image Upgrade is leveraged, but no FlexConnect Master AP has been configured, how many image transfers between the WLC and APs will occur?

1. A. 1
2. B. 2
3. C. 5
4. D. 7

Correct Answer: B

Refer to the exhibit. A network administrator deploys the DHCP profiler service in two ISE servers: 10.3.10.101 and 10.3.10.102. All BYOD devices connecting to WLAN on VLAN63 have been incorrectly profiled and are assigned as unknown profiled endpoints. Which action efficiently rectifies the issue according to Cisco recommendations?

1. A. Nothing needed to be added on the Cisco WLC or VLAN interfac
2. B. The ISE configuration must be fixed.
3. C. Disable DHCP proxy on the Cisco WLC.
4. D. Disable DHCP proxy on the Cisco WLC and run the ip helper-address command under the VLAN interface to point to DHCP and the two ISE servers.
5. E. Keep DHCP proxy enabled on the Cisco WLC and define helper-address under the VLAN interface to point to the two ISE servers.

Correct Answer: C

A new MSE with wIPS service has been installed and no alarm information appears to be reaching the MSE from controllers. Which protocol must be allowed to reach the MSE from the controllers?

1. A. SOAP/XML
2. B. NMSP
3. C. CAPWAP
4. D. SNMP

Correct Answer: A