300-415 Free Practice Test

Which destination UDP port is used by WAN Edge router to make a DTLS connection with vBond Orchestrator?

1. A. A.-12343B.12345C.12346D.12347

Correct Answer: C

An engineer is tasked to improve throughput for connection-oriented traffic by decreasing round-trip latency. Which configuration will achieve this goal?

1. A. turn on "Enable TCP Optimization"
2. B. turn off "Enhance ECMP Keying"
3. C. turn off "Enable TCP Optimization"
4. D. turn on "Enhance ECMP Keying"

Correct Answer: A

https://www.cisco.com/c/dam/en/us/td/docs/routers/sdwan/configuration/config-18-2.pdf#page=530

Which pathway under Monitor > Network > Select Device is used to verify service insertion configuration?

1. A. Real Time
2. B. System Status
3. C. ACL Logs
4. D. Events

Correct Answer: A

https://www.cisco.com/c/en/us/td/docs/routers/sdwan/configuration/policies/vedge-20-x/policies-book/service-c

Refer to the exhibit.

The network team must configure branch B WAN Edge device 103 to establish dynamic full-mesh IPsec tunnels between all colors with branches over MPLS and Internet circuits. The branch ts configured with:


Which configuration meets the requirement?
A)

B)

C)

D)

1. A. Option A
2. B. Option B
3. C. Option C
4. D. Option D

Correct Answer: A

Where on vManage does an engineer find the details of control node failure?

1. A. Alarms
2. B. Events
3. C. Audit log
4. D. Network

Correct Answer: A
https://www.cisco.com/c/en/us/td/docs/routers/sdwan/vManage_How-Tos/vmanage-howto-book/m-troubleshoot