300-410 Free Practice Test

- (Exam Topic 2)

Refer to the exhibit. The remote server is failing to receive the NetFlow data Which action resolves the issue?

1. A. Modify the flow transport command transport udp 2055 to move under flow monitor profile.
2. B. Modify the interlace command to Ip flow monitor FLOW-MONITOR-1 Input.
3. C. Modify the udp port under flow exporter profile to Ip transport udp 4739.
4. D. Modify the flow record command record v4_r1 to move under flow exporter profile.

Correct Answer: B
From the exhibit we see there are two flow monitors: the first one “FLOW-MONITOR-1” has been configured correctly but the second one “v4_r1” was left empty andinterface E0/0.1 is using it. So the remote server does not receive any NetFlow data.

- (Exam Topic 1)
Refer to the exhibit.

After redistribution is enabled between the routing protocols; PC2, PC3, and PC4 cannot reach PC1. Which action can the engineer take to solve the issue so that all the PCs are reachable?

1. A. Set the administrative distance 100 under the RIP process on R2.
2. B. Filter the prefix 10.1.1.0/24 when redistributed from OSPF to EIGRP.
3. C. Filter the prefix 10.1.1.0/24 when redistributed from RIP to EIGRP.
4. D. Redistribute the directly connected interfaces on R2.

Correct Answer: A

- (Exam Topic 1)
Refer to the exhibit.

What is the result of applying this configuration?

1. A. The router can form BGP neighborships with any other device.
2. B. The router cannot form BGP neighborships with any other device.
3. C. The router cannot form BGP neighborships with any device that is matched by the access list named “BGP”.
4. D. The router can form BGP neighborships with any device that is matched by the access list named “BGP”.

Correct Answer: C
after bgp session are UP.I configured the CoPP to drop 10.3.3.3 bgp traffic (R3). R3 bgp traffic that matched the ACL 100 is dropped and the state is in IDLE
-------------------------------------------
access-list 100 permit tcp host 10.3.3.3 any eq bgp access-list 100 permit tcp host 10.3.3.3 eq bgp any
!
class-map match-all class-bgp match access-group 100
!
policy-map policy-bgp class class-bgp
drop
!
control-plane
service-policy input policy-bgp
!
The 10.3.3.3 neighbor goes to IDLE

- (Exam Topic 3)


Refer to the exhibit. When an FTP client attempts to use passive FTP to connect to the FTP server, the file transfers fail Which action resolves the issue?

1. A. Configure active FTP traffic.
2. B. Modify FTP-SERVER access list to remove established at the end.
3. C. Modify traffic filter FTP-SERVER in to the outbound direction.
4. D. Configure to permit TCP ports higher than 1023.

Correct Answer: D

- (Exam Topic 3)
Refer to the exhibit.

The administrator is trying to overwrite an existing file on the TFTP server that was previously uploaded by another router. However, the attempt to update the file fails. Which action resolves this issue?

1. A. Make the packages.conf file executable by all on the TFTP server
2. B. Make the packages.conf file writable by all on the TFTP server
3. C. Make sure to run the TFTP service on the TFTP server
4. D. Make the TFTP folder writable by all on the TFTP server

Correct Answer: B