300-101 Free Practice Test

Which two statements are limitations of stateful NAT64? (Choose two)

1. A. It supports DNS64 only
2. B. Layer 4 supports TCP only
3. C. It is unable to route VRF traffic
4. D. It is unable to route multicast traffic
5. E. It supports FTP traffic only with an ALG

Correct Answer: CD

After reviewing the EVN configuration, a network admin notice that a predefined EVN, which is know as vnet global was configured. What is the purpose of this EVN?

1. A. It refers to the global context and corresponds to the default RIB.
2. B. It aggregates and carries dot1q tagged traffic.
3. C. It defines the routing scope for each particular EVN edge interface.
4. D. It safeguards the virtual that is preconfigure to avoid mismatched routing instances.

Correct Answer: A

Refer to the exhibit.

R1 and R2 are unable to establish an EIGRP adjacency. Which action corrects the problem?

1. A. Change the EIGRP router-id value on one of the routers so that the values on the two routers are different.
2. B. Add the no auto-summary command to the R2 configuration so that it matches the Rl configuration.
3. C. Change the autonomous system number on one of the routers so that each router has different values.
4. D. Chang the IP address and subnet mask on R2 so that it is on the same subnet as R1.

Correct Answer: D

Which command do you enter on router R6 so that BGP supports multiple protocols'?

1. A. R6(config-router-af)#bgp additional-paths install
2. B. R6(config-router-af)#no bgp default ipv4-multicast
3. C. R6(config-router)#no address-family ipv4 unicast
4. D. R6(config-router)#bgp default ipv4-multicast
5. E. R6(config-router)#no bgp default ipv4-unicast I

Correct Answer: E

Which two commands must be configured on a DMVPN hub to enable phase 3? (Choose two )

1. A. ip nhrp redirect
2. B. ip nhrp interest
3. C. ip nhrp shortcut
4. D. Ip nhrp map
5. E. ip redirects

Correct Answer: AD