300-101 Free Practice Test

How to set up IP SLA to monitor Bandwidth between the certain limits?

1. A. Timer
2. B. Frequency
3. C. Threshold
4. D. Queue-limit

Correct Answer: C

Which condition must be met before you can configure SSH on a device running Cisco loS?

1. A. The device must have an auxilary port.
2. B. The device must have a modem connection.
3. C. The loS must be a crypto in
4. D. Telnet must be disabled on the device

Correct Answer: C

Which two statements about DMVPN are true?

1. A. Multicast traffic is not supported
2. B. It requires full-mesh connectivity on the network
3. C. IPsec encryption is not supported with statical addressed spokes
4. D. It uses NHRP to create a mapping database of spoke addresses
5. E. It supports dynamic addresses for spokes in a hub-and-spoke VPN topology

Correct Answer: DE

A route with default RIPv2 settings loses connectivity to it's next-hop neighbor. How long dows the router wait before removing the route to the next hop from its route table?

1. A. 30 seconds
2. B. 60 seconds
3. C. 180 seconds
4. D. 240 seconds

Correct Answer: D

You have a router has some interface configured with 10Gb interface and gigabit interface. Which command you use to optimize higher BW

1. A. (config)#router ospf 1(config-router)auto-cost reference-bandwidth 10000
2. B. (config)#router ospf 1(config-router)auto-cost reference-bandwidth 1000
3. C. (config)#int f0/0(config-int)auto-cost reference-bandwidth 1000
4. D. (config)#int f0/0(config-int)auto-cost reference-bandwidth 10000

Correct Answer: A