200-301 Free Practice Test

- (Topic 2)
An engineer observes high usage on the 2.4GHz channels and lower usage on the 5GHz channels. What must be configured to allow clients to preferentially use 5GH2 access points?

1. A. Re- Anchor Roamed Clients
2. B. 11ac MU-MIMO
3. C. OEAP Split Tunnel
4. D. Client Band Select

Correct Answer: D

- (Topic 4)
Which set of 2.4 GHz nonoverlapping wireless channels is standard in the United States?

1. A. channels 2, 7, 9, and 11
2. B. channels 1, 6, 11, and 14
3. C. channels 2, 7, and 11
4. D. channels 1, 6, and 11

Correct Answer: D
In the United States, while channels 1-13 can be used for 2.4 GHz WiFi, only three channels are considered non-overlapping (channels 12 and 13 are allowed under low powered conditions, but for most cases are not used). For best results, it is highly recommended to keep the 2.4 GHz channels to 1, 6, and 11, as these channel settings will allow for virtually no overlap in the WiFi signal. Shown below is a channel graph from WiFi Scanner showing three access points configured for channels 1, 6, and 11. As you can see, the center of each signal is at 1, 6, and 11 with the actual signal extending over several channels to the left and right.

DRAG DROP - (Topic 4)
Refer to the exhibit.

Drag and drop the learned prefixes from the left onto the subnet masks on the right

Solution:


Does this meet the goal?

1. A. Yes
2. B. No

Correct Answer: A

- (Topic 1)
What are two roles of Domain Name Services (DNS)? (Choose Two)

1. A. builds a flat structure of DNS names for more efficient IP operations
2. B. encrypts network Traffic as it travels across a WAN by default
3. C. improves security by protecting IP addresses under Fully Qualified Domain Names (FQDNs)
4. D. enables applications to identify resources by name instead of IP address
5. E. allows a single host name to be shared across more than one IP address

Correct Answer: DE

- (Topic 4)
Refer to the exhibit.

A Cisco engineer creates a new WLAN called lantest. Which two actions must be performed so that only high-speed 2.4-Ghz clients connect? (Choose two.)

1. A. Enable the Broadcast SSID option
2. B. Enable the Status option.
3. C. Set the Radio Policy option to 802 11g Only.
4. D. Set the Radio Policy option to 802.11a Only.
5. E. Set the Interface/Interface Group(G) to an interface other than guest

Correct Answer: AB