- (Topic 1)
Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?
Correct Answer:
C
Reference: https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst2960/software/release/12-2_37_ey/configuration/guide/scg/swlldp.pdf
+ lldp holdtime seconds: Specify the amount of time a receiving device should hold the information from your device before discarding it+ lldp reinit delay: Specify the delay time in seconds for LLDP to initialize on an interface+ lldp timer rate: Set the sending frequency of LLDP updates in seconds
DRAG DROP - (Topic 4)
Refer to the exhibit. Drag and drop the learned prefixes from the left onto the preferred route methods from which they were learned on the right.
Solution:
Does this meet the goal?
Correct Answer:
A
- (Topic 2)
Refer to the exhibit.
Which change to the configuration on Switch?
allows the two switches to establish an GtherChannel?
Correct Answer:
B
- (Topic 1)
Which two functions are performed by the core layer in a three-tier architecture? (Choose two)
Correct Answer:
AD
Cisco is very clear about the purpose of this layer. Its only role is to forward traffic, the fastest it can. Here you don’t apply any policy, as you must try to reduce the load of the core so it can focus on routing. https://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Campus/campover.html#wp708 831
- (Topic 4)
Which WAN topology has the highest degree of reliability?
Correct Answer:
A
