200-301 Free Practice Test

- (Exam Topic 2)
An engineer configured an OSPF neighbor as a designated router. Which state verifies the designated router is in the proper mode?

1. A. Exchange
2. B. 2-way
3. C. Full
4. D. Init

Correct Answer: C

- (Exam Topic 2)
A network administrator needs to aggregate 4 ports into a single logical link which must negotiate layer 2 connectivity to ports on another switch. What must be configured when using active mode on both sides of the connection?

1. A. 802.1q trunks
2. B. Cisco vPC
3. C. LLDP
4. D. LACP

Correct Answer: D

- (Exam Topic 4)
What is a feature of WPA?

1. A. 802.1x authentication
2. B. preshared key
3. C. TKIP/MIC encryption
4. D. small Wi-Fi application

Correct Answer: A

- (Exam Topic 4)
Refer to the exhibit.

A packet sourced from 172.18.33.2 is destined for 172.18.32.38. Where does the router forward the packet?

1. A. GigabitEthernet0/0
2. B. Loopback0
3. C. 10.1.1.1
4. D. 10.1.1.3

Correct Answer: B

- (Exam Topic 2)
Refer to the exhibit.

Drag and drop the networking parameters from the left onto the correct values on the right.

Solution:
NIC vendor OUI –> 00:0C:22NIC MAC address –> 00:0C:22:83:79:A3default gateway –> 192.168.1.193host IP address –> 192.168.1.200subnet mask –> 255.255.255.192
The “ip route” and “ip addr show eth1” are Linux commands.+ “ip route”: display the routing table+ “ip addr show eth1”: get depth information (only on eth1 interface) about your network interfaces like IP Address, MAC Address information

Does this meet the goal?

1. A. Yes
2. B. No

Correct Answer: A