200-301 Free Practice Test

- (Topic 2)
Refer to the exhibit.

The show ip ospf interface command has been executed on R1 How is OSPF configured?

1. A. The interface is not participating in OSPF
2. B. A point-to-point network type is configured
3. C. The default Hello and Dead timers are in use
4. D. There are six OSPF neighbors on this interface

Correct Answer: C
https://www.cisco.com/c/en/us/support/docs/ip/open-shortest-path-first- ospf/13689-17.html

- (Topic 4)
Which cipher is supported for wireless encryption only with the WPA2 standard?

1. A. AES256
2. B. AES
3. C. RC4
4. D. SHA

Correct Answer: B

- (Topic 4)

A)

B)

C)

D)

1. A. Option A
2. B. Option B
3. C. Option C
4. D. Option D

Correct Answer: D

DRAG DROP - (Topic 4)
Drag and drop the characteristic from the left onto the IPv6 address type on the right.

Solution:


Does this meet the goal?

1. A. Yes
2. B. No

Correct Answer: A

SIMULATION - (Topic 5)

All physical cabling between the two switches is installed. Configure the network connectivity between the switches using the designated VLANs and interfaces.
* 1. Configure VLAN 100 named Compute and VLAN 200 named Telephony where required for each task.
* 2. Configure Ethernet0/1 on SW2 to use the existing VLAN named Available.
* 3. Configure the connection between the switches using access ports.
* 4. Configure Ethernet0/1 on SW1 using data and voice VLANs.
* 5. Configure Ethemet0/1 on SW2 so that the Cisco proprietary neighbor discovery protocol is turned off for the designated interface only.

Solution:
Answer as below configuration:
on sw1 enable conf t vlan 100
name Compute vlan 200
name Telephony int e0/1
switchport voice vlan 200 switchport access vlan 100 int e0/0
switchport mode access do wr
on sw2
Vlan 99
Name Available Int e0/1
Switchport access vlan 99 do wr

Does this meet the goal?

1. A. Yes
2. B. No

Correct Answer: A