156-315.81 Free Practice Test

- (Exam Topic 4)
If the Active Security Management Server fails or if it becomes necessary to change the Active to Standby, the following steps must be taken to prevent data loss. Providing the Active Security Management Server is responsive, which if these steps should NOT be performed:

1. A. Rename the hostname of the Standby member to match exactly the hostname of the Active member.
2. B. Change the Standby Security Management Server to Active.
3. C. Change the Active Security Management Server to Standby.
4. D. Manually synchronize the Active and Standby Security Management Servers.

Correct Answer: A

- (Exam Topic 4)
You need to change the MAC-address on eth2 interface of the gateway. What command and what mode will you use to achieve this goal?

1. A. set interface eth2 mac-addr 11:11:11:11:11:11; CLISH
2. B. ifconfig eth1 hw 11:11:11:11:11:11; expert
3. C. set interface eth2 hw-addr 11:11:11:11:11:11; CLISH
4. D. ethtool -i eth2 mac 11:11:11:11:11:11; expert

Correct Answer: A

- (Exam Topic 4)
What are the minimum open server hardware requirements for a Security Management Server/Standalone in R81?

1. A. 2 CPU cores, 4GB of RAM and 15GB of disk space
2. B. 8 CPU cores, 16GB of RAM and 500 GB of disk space
3. C. 4 CPU cores, 8GB of RAM and 500GB of disk space
4. D. 8 CPU cores, 32GB of RAM and 1 TB of disk space

Correct Answer: C

- (Exam Topic 4)
You have enabled “Full Log” as a tracking option to a security rule. However, you are still not seeing any data type information. What is the MOST likely reason?

1. A. Logging has disk space issue
2. B. Change logging storage options on the logging server or Security Management Server properties and install database.
3. C. Data Awareness is not enabled.
4. D. Identity Awareness is not enabled.
5. E. Logs are arriving from Pre-R81 gateways.

Correct Answer: A

- (Exam Topic 1)
What are the attributes that SecureXL will check after the connection is allowed by Security Policy?

1. A. Source address, Destination address, Source port, Destination port, Protocol
2. B. Source MAC address, Destination MAC address, Source port, Destination port, Protocol
3. C. Source address, Destination address, Source port, Destination port
4. D. Source address, Destination address, Destination port, Protocol

Correct Answer: A