010-151 Free Practice Test

Which command can be used to exit to EXEC mode from this current mode?
switch(config-if) #

1. A. Ctrl-C
2. B. Ctrl-L
3. C. quit
4. D. exit
5. E. end

Correct Answer: E

How do you find the serial number of a Cisco UCS 5108 Blade Server chassis?

1. A. Use the Cisco UCS Admi
2. B. Use the Cisco UCS Applicatio
3. C. Use the Cisco UCS Assistan
4. D. Use the Cisco UCS Manage

Correct Answer: D

After installation or replacement of a Cisco UCS C-Series Rack-Mount Server, the host does not boot.
Which four options should be verified? (Choose four.)

1. A. Verify the power source to the equipmen
2. B. Check for loose HDD cable
3. C. Reseat the DIMMs, CPU, and PCI card
4. D. Verify that power supplies are receiving powe
5. E. Reseat the mezzanine card connecto
6. F. Check the CPU sockets for bent pin
7. G. Check the Cisco IMC for fan fault

Correct Answer: ACDF

Which three troubleshooting procedures do you perform when there is no power to a Cisco UCS B250 M2 Blade Server? (Choose three.)

1. A. Decommission and acknowledge the blad
2. B. Check the back of the blade to ensure that there is no damage to the connection that goes into chassi
3. C. Reseat the memory DIMM
4. D. Check the CPU sockets for bent pin
5. E. Reseat the blade in the same slot in the chassi
6. F. Move the blade to another slot in the chassi

Correct Answer: BEF

What is the correct path to verify the Overall Status of Chassis 1 | Server 3?

1. A. Equipment Tab > Chassis > Chassis 1 > Servers > Server 3 Status tab
2. B. Equipment Tab > Chassis > Chassis 1 > Servers > Server 3 General tab
3. C. Equipment Tab > Chassis > Chassis 1 > Servers > Server 3 FSM tab
4. D. Servers Tab > Chassis > Server 3 General tab
5. E. Status Tab > Chassis > Chassis 1 > Servers > Server 3
6. F. Admin Tab > Chassis > Chassis 1 > Servers > Server 3 General tab

Correct Answer: B